Monday, June 15, 2009

A baby coil winder was born...

Although the coil winder only had a few weekends at may house, it manages to give birth to a new baby winder as shown below... :-)

Made from an old RC servo motor, the baby winder has smaller shaft (M6) thus I could wind smaller cores. It's a simple setup. The servo electronics was gutted and the power is connected direct to a power supply. The on-off switch is there to control the baby during winding. The bolt was sandwiched between two plastic plates (courtesy of my cnc) and fixed with epoxy. The shiny aluminum foil is for me to count the number of revolution. The setup is running at 60rpm with a 6V supply.

No comments: